Handling Flat Mesh Panels Before Site Use

Flat panels can lose accuracy when they are dragged, stacked poorly, or pressed by heavy uneven loads. welded wire mesh panels should be lifted by more than one worker when the sheet is large. Dragging one edge across concrete can bend corners and scratch coating. Once the panel is bent, it may not sit flat on the work surface.

Storage should be simple and orderly. Keep panels on level supports and place the same size together. Do not mix coated panels with sharp steel parts. When panels are prepared for floor heating or reinforcement work, the sheet direction and opening size should be checked before the batch is moved to the site position.

Before fixing, workers can review three points: panel size, weld point condition, and surface damage. Bent corners should be straightened. Scratched coating should be repaired when the project needs corrosion protection. Good handling keeps welded wire mesh panels easier to align and helps the next process run without repeated adjustment. Leave enough walking space around the stack, and do not place wet materials above the panels. These small habits reduce wasted sheets before installation starts. It also keeps panels easier to count before work begins.